Two years ago I started a number of crabapple from seed. They’re do for some wiring.

Two year-old crabapple seedlings

The variety, Malus sieboldii, or zumi, must like it cold because they have yet to lose more than a few leaves.

Zumi leaf

Before wiring, I removed the foliage.

After removing the leaves

One tip – I found that the leaves, including the petioles, come of much easier when pulling them backward, or toward the soil, instead of forward.

It’s also a good idea to remove young trees from the pot before wiring as the surface roots are often buried below the surface.

Crabapple seedling

As seen from below

The pot is an Anderson cross-bottom band pot. Cross-bottom bands do a good job of keeping the soil from remaining too wet with the main caveat being that it’s not convenient to remove a single plant from the flat until it’s rooted in. These plants rooted in just fine after one year.

Well rooted-in seedling

I dug down and discovered that the roots emerged from the trunk near the bottom of the pot.

After finding the base of the trunk

I applied some wire and replanted the seedlings in larger Anderson Bands.

After wiring

Seedlings planted in larger Anderson Bands

I planted the remaining seedlings in 4″ pots. Here’s one that was growing in straight kanuma.

Seedling in kanuma – the roots look great!

After planting in a 4″ pot with regular bonsai soil

The repotted trees were all planted in a mix of roughly 1 part each akadama, pumice and lava, though it appears that kanuma could be an acceptable alternative.

After repotting

I’ll let these grow freely until the wire starts cutting in, likely sometime next spring. After that, I’ll either re-wire or let the trunks continue to thicken without wire through the growing season.

The post Wiring and repotting crabapple seedlings appeared first on Bonsai Tonight.